 |
|
Hard drive profile
 |
| Date added: |
2006-11-01 |
Posted by: |
imbout |
| Brand: |
Western Digital |
Firmware: |
N/A |
| Model number: |
WD800JB-00JJA0 |
Manufacture date: |
2005-01-15 |
| Model name / serie: |
N/A |
Buffersize: |
8 MB |
| Drive size: |
80 GB |
RPM: |
7200 |
| PS2 version: |
v3 |
Progam(s): |
HDAdvance |
| Adaptor model: |
Ethernet and Modem |
|
|
|
| Additional notes: |
|
Report this entry - Edit |
| Worked with modifications to the network adapter. I had to take some of the metal off near the pwer connector and remove the torx-7 holding it down to make it fit the hard drive. Also had to move the jumper cable to cable select to make HDAdvance recognize the hard drive. I had it set at master and HDAdvance would show an error messages stating that no HDD hardware was detectable and to check to make sure that it was connected to the PS2. Found almost all my info on my HDD on this site. Used others info to help with my installation. |
Comments
| #1 - posted by MetA (70.246.23*.*) | 2007-08-11 22:12:05 |
| It's Torx-6, not 7. Just a small correction. and no, i wont go back here to see your reply so get mad if you want, but it's torx 6. |
| #2 - posted by MetA (70.246.23*.*) | 2007-08-11 22:12:22 |
| It's Torx-6, not 7. Just a small correction. and no, i wont go back here to see your reply so get mad if you want, but it's torx 6. |
|
