 |
|
Hard drive profile
 |
| Date added: |
2004-12-30 |
Posted by: |
chorting |
| Brand: |
Western Digital |
Firmware: |
N/A |
| Model number: |
WD400BB |
Manufacture date: |
N/A |
| Model name / serie: |
N/A |
Buffersize: |
2 MB |
| Drive size: |
40 GB |
RPM: |
7200 |
| PS2 version: |
v7 |
Progam(s): |
HDLoader/HDAdvance |
| Adaptor model: |
Ethernet and Modem |
|
|
 |
| Model picture (exact model) |
|
| Additional notes: |
|
Report this entry - Edit |
THIS DRIVE WILL WORK, BUT THESE TWO STEPS MUST BE FOLLOWED:
1. Unscrew the aluminum casing on the PS2 Network Adapter at the bottom, fold the metal up, and use a T-8 (otherwise known as a Torx or Star driver) to remove the power adapter from the casing. DO NOT USE A REGULAR PHILLIPS OR FLATHEAD - YOU WILL STRIP THE SCREW. Clip the aluminum between the power adapter and the screwhole (to allow the power adapter to move freely to the side). Put a piece of electrical tape on the back of the power adapter and bend the aluminum back into place. Put the right-side screw back into the casing (the one nearest to the IDE connector).
2. Place the jumper between pins 4 and 6 (pins are 1-10 going from left to right, with odd on top and even on bottom). |
Comments
| #1 - posted by chorting (63.162.14*.*) | 2004-12-30 18:31:56 |
| Corrected jumper instruction in second post - 10 is on left, 1 is on right |
|
