Navigation: Drive List Submit Your Drive Installation Tips Statistics Feedback Help Privacy About
 

Hard drive profile

Date added: 2004-12-30 Posted by: chorting
Brand: Western Digital Firmware: N/A
Model number: WD400BB Manufacture date: N/A
Model name / serie: N/A Buffersize: 2 MB
Drive size: 40 GB RPM: 7200
PS2 version: v7 Progam(s): HDLoader/HDAdvance
Adaptor model: Ethernet and Modem
Fitting:
Yes
Working:
Yes

Model picture (exact model)
Additional notes: Report this entry - Edit
THIS DRIVE WILL WORK, BUT THESE TWO STEPS MUST BE FOLLOWED:

1. Unscrew the aluminum casing on the PS2 Network Adapter at the bottom, fold the metal up, and use a T-8 (otherwise known as a Torx or Star driver) to remove the power adapter from the casing. DO NOT USE A REGULAR PHILLIPS OR FLATHEAD - YOU WILL STRIP THE SCREW. Clip the aluminum between the power adapter and the screwhole (to allow the power adapter to move freely to the side). Put a piece of electrical tape on the back of the power adapter and bend the aluminum back into place. Put the right-side screw back into the casing (the one nearest to the IDE connector).

2. Place the jumper between pins 4 and 6 (pins are 1-10 going from left to right, with odd on top and even on bottom).

Comments

#1 - posted by chorting (63.162.14*.*)2004-12-30 18:31:56
Corrected jumper instruction in second post - 10 is on left, 1 is on right

Name HTML not allowed!
E-mail Optional (Spam protected)
Verification - Enter code